Hi,
Done this loads of times after labling up the contours, and even on the drawing I'm working on now did it and was fine. Then some how as well as seeing the smooth contours lines, next to them are the old straight ones.
Tried making new contours and then smoothing them. Still the same finish seeing both the smooth and the straight lines. Also same effect when working in inCAD.
Any ideas?
Peter
Smooth Contours
Moderators: Brian Sloman, Jason Poitras, James Johnston
- Brian Sloman
- Product Manager
- Posts: 407
- Joined: Fri Jan 07, 2005 4:42 pm
- Location: Westbank, BC, Canada
- Contact:
Re: Smooth Contours
Hi, most likely the Spline Control Frame Lines have been turned on in this drawing - type SPLFRAME and make sure it is set to Off.
Brian Sloman
Development Manager
MicroSurvey Software Inc.
Development Manager
MicroSurvey Software Inc.