Cogo

Eric Anderson · Post by **Eric Anderson** » Wed Aug 10, 2011 7:52 am

Is it possible to add another code to the Cogo bearing codes (Currently 1=NE, 2=SE, 3=SW, 4=NW)? e.g. 5=North/South Azimuth

Darcy Detlor · Post by **Darcy Detlor** » Sat Aug 13, 2011 8:14 am

Hi,

I wrote the core of COGO in MicroSurvey a little over 20 years ago, and I'm curious what exactly do you mean by North/South azimuth?

Eric Anderson · Post by **Eric Anderson** » Mon Aug 15, 2011 6:48 am

e.g.

I'm working on a drawing in bearings and most of my existing field work is in bearings, but I receive some field data/traverse data that uses azimuths and I want to compute that information without having to change my drawing settings to azimuths.

Darcy Detlor · Post by **Darcy Detlor** » Mon Aug 15, 2011 7:10 am

Great idea. So 5270.3456 would be 270 degrees, 34 minutes, 56 seconds. We would probably choke on the 4 characters before the decimal point right now, but that would be easy to fix.

Eric Anderson · Post by **Eric Anderson** » Mon Aug 15, 2011 7:14 am

Darcy Detlor wrote:Great idea. So 5270.3456 would be 270 degrees, 34 minutes, 56 seconds. We would probably choke on the 4 characters before the decimal point right now, but that would be easy to fix.

Sweet Chickens!!

That would be awesome! You probably would need a program setting to determine if someone is working with North or South Azimuths.

This is also tied in with my concern on this thread:

http://www.microsurvey.com/forum/viewto ... f=3&t=2108

Eric Anderson · Post by **Eric Anderson** » Fri Aug 17, 2012 6:03 am

Is there a way to go back in Cogo if you enter in a wrong bearing/azimuth or distance without exiting the Cogo routine?

Nevermind, I figured it out!

MicroSurvey Software Inc.

Cogo

Cogo

Re: Cogo

Re: Cogo

Re: Cogo

Re: Cogo

Re: Cogo