Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
Richard Sands


Post by Richard Sands » Mon Dec 16, 2002 11:35 am

When using COPYSELECT all works as planned except the screen zooms right out at the end. I dont remember previous versions doing this - this is with 2002 SP2.

Mark Budgen

Post by Mark Budgen » Mon Dec 16, 2002 11:50 am

Hi Richard,

The extents of what you are copying are set as the extents of the drawing. This was done in error and has been corrected. The fix will be made available in the next service pack.

If you do a REGEN, the drawing extents will be correctly reset to the drawing extents. I hope this helps. :D

Post Reply