Modifying Work

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
Posts: 94
Joined: Wed Aug 27, 2003 8:45 am
Location: ILLINOIS

Modifying Work

Post by CHRIS L » Fri Feb 25, 2005 9:22 am

If you completely run through the entire road establishment....set up alignments, profiles and run the cross sections sheet and then go back and modify say the profile, will it automatically update the cross sections to the new data or do you need to run through the entire process again?

Glen Cameron
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada


Post by Glen Cameron » Fri Feb 25, 2005 9:45 am

If you make any changes along the way - you must reprocess everything from that point forward to get new results. There is no dynamic update option. So erase the sections and re-calc them using the new design profile and the appropriatye cross section template to create a new surface, etc.

Glen W. Cameron, C.E.T.
City of North Bay, Ontario

Post Reply