Drawing 0

Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
Posts: 22
Joined: Tue Feb 22, 2005 8:05 pm
Location: Surrey, BC

Drawing 0

Post by shamus » Mon May 16, 2005 10:02 am

Is there anyway to make it so that drawing 0 doesn't open every time I start Microsurvey.

John Gallagher
Posts: 64
Joined: Fri Nov 08, 2002 1:35 pm
Location: Long Island New York

Drawing 0

Post by John Gallagher » Mon May 16, 2005 10:42 am

go to the windows folder and find the mscad2004.ini file.
Open it up in Notepad or Wordpad and look for the line that starts

New in FelixCAD 6.0

Change AutoNew=1 to AutoNew=0 and that eliminates the new drawing starting up when you start MSCAD.
Be forewarned though,copy the original .ini file to a safe place before making any changes,so far I haven't run into any problems but if I do the original file is safe and sound on my hard drive and on a floppy so I can restore it if a problem does crop up.
Hope this helps,
John Gallagher

T.M. Moretz
Posts: 79
Joined: Fri Nov 08, 2002 1:31 pm
Location: North Carolina, USA

FCAD 6.0?

Post by T.M. Moretz » Mon May 16, 2005 5:24 pm

I thought that ICAD was the engine of the future.

Glen Cameron
Posts: 1395
Joined: Fri Nov 08, 2002 12:18 pm
Location: Corbeil, Ontario, Canada


Post by Glen Cameron » Mon May 16, 2005 6:27 pm

IntelliCAD 6.0 is the engine we have chosen for MSCAD2005.
Always getting better and moving forward!

Glen W. Cameron, C.E.T.
City of North Bay, Ontario

Post Reply