Discussion of MicroSurvey CAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply
Richard Sands


Post by Richard Sands » Fri Jul 02, 2004 5:43 pm

Just a few ideas on new features. What do others think?
1-Labels at 90 degrees (or 45 degrees?) to the lines. Currently only available parallel to them.
2-'Floating' Layouts that cover what is behind them. Ie ability to have an enlarged portion of Model in Paper Space without having to find a blank spot on the layout.
3-AutoAdd Points or EDITP or just plain COGO. ability to set default Description that is used for all such entries.
I have forwarded these to MicroSurvey, but maybe others have comments here too.
Richard Sands

T.M. Moretz
Posts: 79
Joined: Fri Nov 08, 2002 1:31 pm
Location: North Carolina, USA

Good ideas

Post by T.M. Moretz » Sat Jul 03, 2004 4:36 am

I too suggested your #3. I was hoping that the default description would be something that could be set each time the routine was started as opposed to a setting that was buried in the program defaults somewhere. I also think it would be nice if the routine (Autoadd points) could apply a default description to the radius point - this default could be in the program defaults because it would never change.

Post Reply