Proportion on Arc

Discussion of MicroSurvey inCAD related issues and questions.

Moderators: Brian Sloman, Jason Poitras, James Johnston

Post Reply

Proportion on Arc

Post by Guest » Wed Aug 18, 2004 8:42 am

when I proportion an arc with the draw lines/curves set on my toggles I get an error drawing arc and no new points are created. If I turn off the draw lines/curves in my hot toggles the arc proportion command works.

ACAD2002 Incad 2004

Cary Glazier

Curve Proportion

Post by Cary Glazier » Wed Aug 18, 2004 8:55 am

I think the problem is the object snaps need to be set to none and the command is not doing it...I cleared my osnaps and it worked.

Post Reply